Here is an easy homemade gift idea for almost everyone, or every room. A light switch plate! There are few supplies needed:
- Plastic Switch Plate
- Mod Podge (glue)
- X-acto Knife
- Old Calendars or colorful paper (not too thin)
Begin by selecting a special piece of paper. Next, cut the paper so that is apprximately 1 1/2 inches larger than the size of your switch plate. Then cut the corners as shown below.
Place the switch plate on the paper and trace the outline for the center hole. Make diagonal cuts as shown in previous image. Brush glue (Mod Podge) on on paper and put switch plate in place.
Fold side and inside flaps, pressing firmly until glue sticks.
Poke holes for srews, making sure to poke from the front side of the switch plate.
Coat paper with with Mod Podge or spray with a clear varnish. You are done!